Car Maintenance five errors

Use and maintenance people in the car have some misconceptions , false belief that in the automotive manufacturing and repair methods behind these low levels , the formation of a lack of testing means long years . These false beliefs , and sometimes seems to be correct , is not the case, great harm will be loss of vehicles , personal safety is threatened, but more likely is buried in the ground of an accident or vehicle performance, the results of accelerated wear caused by , shortened life expectancy and so on. Rover conservation experts introduce you to car maintenance five errors:

 1, the split blind thermostat if the engine temperature is high, the engine thermostat blind removal, cooling fluid may be a loop, the cooling intensity can’t be adjusted, it is difficult to ensure the proper working of the engine temperature is increased, but the operation of the engine and therefore at low temperatures, often resulting in decreased engine power, accelerated wear and increase fuel consumption. Repair or replacement of the thermostat if the engine fails, the engine temperature is high, the other parts of the cooling system should fix the thermostat can’t be eliminated.

2, high engine temperatures low for fear of fear, the fear that some people think that height is not afraid to drive the engine temperature is low. In fact, the engine temperature is low is a great harm. Description should be at room temperature to drive a car, to ensure engine life.

3, water pump fan belt tight belt tightening may not be as possible. Stretched too tight or broken belt, not only shorten the life of the belt, but also due to excessive stress, resulting in the generator shaft, water pump shaft and bearing damage early bending deformation. Tightness of the engine fan belt should meet the technical requirements, the normal deflection of 10 - 15mm with the General Assembly is appropriate.

4, the engine idle temperature and the heating, because the speed is low, the pump lubricating oil can quickly enter surface pressure is very low, so that moving parts or semi-arid dry friction engine friction in the state work; fuel atomization due to the cold, so not burning fuel into the crankcase, the cylinder wall wash away the film will accelerate the wear parts. Therefore, a few seconds after the engine starts, the fast idle temperature applications, improve engine lubrication.

5 , the end of winter when the torch and torch oven baked oily end , not only oil additive chemical changes , the loss of the original performance , but also the oil well cement , petroleum deformed end , easy to fire. The best method is based on oil prices in the winter minimum temperature suitable for use. In areas where conditions permit,Autel MaxiScan MS509 preferably with car parking facilities in the insulation. Removal method is to remove the more advanced ultrasonic spray method and nuclear clearance method, but the most common and easiest way is to remove the physical and chemical removal method. Both methods can be used along.

There are many good diagnostic tools, such as: MaxiDAS DS708 Tool, Launch CRP 123 and so on. If you want know about car maintenance information, please click below site: http://www.autointhebox.com